Seat covers should snug fit the seat with no sagging ends. Though it requires a very few instruction to follow, the process of installation is very important. There are a few important instructions to follow when attempting to install car seat covers, though the installation method will vary depending on the type and style of seat covers you have.
In the case of universal bucket seats, firstly take off headrest and place seat cover over the top of seat and pull it down over the seat. Then place bottom of seat cover nicely over seat bottom. After that, fit base of cover snugly over seat. Later, fasten elastic under seat with supplied “S” hooks. At last, tie the supplied cord in position to ensure that the seat cover is held in correct shape. Check the seat cover is perfectly fitting the seat. After all the processes are over, re-install the headrest.
Installation of custom fit seat covers requires more steps than any other car seat covers. Firstly, remove any guards or shields covering original material that may obstruct seat cover installation. Install bottom of seat cover first. Tie three strings provided to bottom seat cover flap and attach to loops on the flap and fasten them under the seat to springs or to another opposing loop on the seat cover. Next place the seat cover backrest on the seat backrest Tie strings or straps to loops on the seat cover backrest. Then feed the strings or straps between the bottom and backrest of the seat and fasten them to corresponding loops on the top or sides of the seat cover. Make sure that seat covers are fitting correctly. Then, make small holes in the seat cover fabric to accommodate headrests and hardware. After all the processes are over, re-insert headrests and hardware.